|
|
Civinco's Stand Alone System
With the Stand Alone Engine management systems, you will easily optimize
your engine. The system controls all the critical parameters like fuel,
ignition, boost and warning systems. All data is stored on memory cards
and can easily be changed during operation. The Stand Alone Systems
are intended for use where the factory PCM is replaced or one does not
exist.
- 3D fuel map with selectable number of cells up to18*19 cells
- 2 fuel maps, which can be combined as preferred.
- Fuel compensation
- Extra load sensor
- Coolant temp, Air temp, Battery voltage
- Acceleration enrichment
- Ignition map based on 21 RPM cells, and selectable load sensor with 33 cells.
- Sequential fuel timing
- Over 25 different cam and crank sensor configurations (60-2, 22-2, 24, 36-2 etc)
- Most ignition orders for 4, 6 and 8 cylinders
- AFR closed loop
- Short and long term adaptive
- Launch control for boost spool up
- Tunable Ignition retard, Rev limit and extra fuel
- Idle control
- Ignition
- Idle control valve with 1 or 2 PWM
- Boost control
- Open or closed loop (PID) via PWM
- Warning systems and error codes
- RPM limiter
- Fuel cut at over boost
- ASD output to control supply voltage to fuel pump etc
- All output and input can be reconfigured for different functions
- Uses all original sensors, so no extra sensors are needed to be purchased
- USB communication with PC
- Log up to 75 engine and sensor signals to PC via
USB
Supported engines
